The transmitter’s multifunction button can be used to switch to a preset backup frequency if interference is encountered.
Features
- Extremely wide 60 MHz UHF tuning bandwidth for maximum versatility in an increasingly congested RF environment; available in two frequency bands: DE2 (470–530 MHz) and EE1 (530–590 MHz)
- Unique multifunction button on the handheld and body-pack transmitters can be used to switch to a backup frequency (on both transmitter and receiver) should interference be encountered
- Network-enabled system, featuring the ATW-R3210N receiver, offers network monitoring and control via Wireless Manager software
- True Diversity operation reduces dropouts
- Auto Squelch feature automatically adjusts squelch setting to maximize range while minimizing potential interference
- Frequency scan and IR sync functionality for ease of setup
- Dual-mode receiver display can switch between standard view or a performance view that highlights key metering
- Transmitters and receivers include OLED screens for optimal readout of key settings and alerts
- Handheld transmitter offers extremely low handling noise and includes an industry-standard thread mount for use with six interchangeable A-T microphone capsules, as well as other compatible capsules
- New rugged cH-style connector on body-pack transmitter provides secure connection to lavalier mics, headworn mics, and cables with cH-style screw-down 4-pin connector
- Body-pack transmitter features tactile mute toggle switch (defeatable) for physical confirmation of mute status when transmitter display is not visible
- Charging terminals on transmitters work with optional ATW-CHG3 and ATW-CHG3N smart charging docks to recharge NiMH batteries
- Antenna power available for powered antennas and other in-line RF devices
- Ground-lift switch helps eliminate audible hum caused by ground loops
- Balanced and unbalanced audio output jacks
Overall System |
Operating Frequencies |
Band DE2: 470.125 to 529.975 MHz (2395 frequencies) Band EE1: 530.000 to 589.975 MHz (2400 frequencies) Band EF1: 590.000 to 649.975 MHz (2400 frequencies) Band FG1: 650.000 to 699.875 MHz (1996 frequencies) |
Operating Frequencies |
Band DE2: 470.125 to 529.975 MHz (2395 frequencies) Band EE1: 530.000 to 589.975 MHz (2400 frequencies) Band EF1: 590.000 to 649.975 MHz (2400 frequencies) Band FG1: 650.000 to 699.875 MHz (1996 frequencies) Please note that some frequency bands might not be available in your territory or could come with a limited tuning bandwidth / transmitting power due to local regulations. |
Minimum Frequency Step |
25 kHz |
Modulation Mode |
FM |
Maximum Deviation |
ATW-T3201: ±38 kHz (THD:10%) ATW-T3202: ±36 kHz (THD:10%) |
Frequency Response |
ATW-T3201: 31 Hz to 15,500 Hz ATW-T3202: 25 Hz to 16,700 Hz Frequency response depends on attached microphone element |
Operating Range |
100 m (328') Open range environment with no interfering signals. |
Total Harmonic Distortion |
<1.0% (at 1 kHz, ±17.5 kHz deviation) |
Operating Temperature Range |
-5° C to +45° C (23° F to 113° F) |
Simultaneous Use |
40 Channels per band* For assistance with multi-band operation or other frequency coordination issues, please contact your regional Audio-Technica customer service representitive. *Region and band dependent |
Body Pack |
RF Power Output |
High: 30 mW, Low: 10 mW (switchable), at 50 ohms |
Battery Life |
High: 8.0 hours (alkaline), Low: 9.0 hours (alkaline) High: 9.0 hours (Ni-MH 1900mAh), Low: 9.5 hours (Ni-MH 1900mAh) Depending on battery type, usage, and environmental conditions. |
Battery Type |
Two 1.5V AA, not included |
Dimensions |
64 mm x 82 mm x 23 mm (W x D x H) 2.52" x 3.22" x 0.91" (W x D x H) |
Input Connections |
cH-style screw-down 4-pin connector Pin 1: GND Pin 2: INST INPUT Pin 3: MIC INPUT Pin 4: DC BIAS +5V |
Net Weight |
102 g (3.6 oz), without batteries |
Spurious Emissions |
Following Federal and National Regulations |
High-pass (low-freq. roll-off) |
125Hz, 12dB/octave |
Receiver |
Receiving System |
True Diversity |
Image Rejection |
60 dB nominal |
RF Sensitivity |
20 dBuV at 60 dBA S/N ratio (50 ohms termination) |
Maximum Output Level |
XLR, balanced: +14 dBV 6.3 mm (1/4"), unbalanced: +8 dBV |
Antenna Input |
BNC-type, 50 ohms |
Antenna Power |
12 V DC, 160 mA (combined) |
Power Supply |
100-240V AC (50/60 Hz) to 12V DC 1A (center positive) switched mode external power supply |
Dimensions |
210.0 mm x 191.0 mm x 43.4 mm (W x D x H) 8.27" x 7.52" x 1.71" (W x D x H) |
Weight |
1100 g (38.8 oz), without accessories |
Accessories Included |
Two flexible UHF antennas; AC adapter (country dependent); rack-mount Adapters |
CONSUMER ALERT Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones.